Русский Deutsch

ATMEL ATMEGA328P AVR PPM Encoder V1.0 Version for APM Pixhawk Flight Controller

SKU: 334767
In Stock
Price: $9.15
Worldwide Free Shipping
Introduction: The PPM Encoder plugs into the PWM servo output ports of any R/C receiver and encodes them into a PPM pulse suitable for many autopilots (e.g. Pixhawk). Modifications to the R/C receiver are not necessary. The whole project is based around the ATMEL ATMEGA328p AVR processor and all timing is done within interrupts so accuracy and stability is optimized. Firmware is free and was created by John Arne and Olivier Adler. The design of the PPM Encoder is based on the Paperazzi PPM Encoder. Important Note: The firmware comes pre-configured to read 8 Channels. In case you would like to change the settings of the PPM encoder to invert the PPM signal and change the fail safe pre-defined values you will need an AVR ISP programmer in order to reprogram it. The jumper on the board no soldering default. In this case the board powered by FC



General
Brand: ZnDiy-BRY
Model: V1.0
Color: Blue
Material: PCB + Plastic
Quantity: 1Piece

Specification
Compatible Model: APM Pixhawk Flight Controller

Other Features
Other Features: Specification: Support input channel:8 Output:PPM SUM ×1 / MUX ×1 Size:28mm x 19mm x 5mm Weight: 9g With ArduPPM_v2.3.16 firmware http://copter.ardupilot.cn/wiki/common-ppm-encoder/

Dimensions & Weight
Dimensions: 1.1 in x 0.75 in x 0.2 in (2.8 cm x 1.9 cm x 0.5 cm)
Weight: 0.53 oz (15 g)

Packing List

1 x PPM encoder
1 x JR plug 10P input connect cable ( 60mm )
1 x JR plug 4P output connection cable (100mm )
Tags:

flight simulator encoder

,

atmel studio version control

,

flightgear v1 0 full game

,

virgin flight status

,

asf version atmel

,

flight version swiss army knife

,

encoder control

,

flight controller salary