Русский Deutsch

MaiTech LCD Monitor Power Supply Universal Module - Black

SKU: 302116
In Stock
Price: $3.1
Worldwide Free Shipping
Purpose: to solve the 17-21 inch LCD monitor power failure maintenance problems

Pin Definitions

Yellow Line: DRAIN, power control terminal connected to the original high-power MOS tube D pole.

Black line: GND, the module ground 300v, then negative capacitance can be on the same line.

Red: VCC, module supply side, the positive feedback received after the end of the rectifier winding capacitance, continuity of supply voltage between 12-18V.

White lines: FB, regulator feedback, then optocoupler 4 feet, 3 feet to make sure optocoupler heat, the earth is not hot, then put the optocoupler shorted to ground heat, while the 4-pin peripheral circuit is disconnected. '

Green Line: start start foot, connected +300 V capacitor positive.

Usage:

1. Remove the power chip (typically 8 feet) on the original board, and switch (mos tube)

2. Check 300v capacitor, there was the appearance on the load side of the capacitor is no drum kits, there are problems on the first replacement

3. Check the load side there is no short circuit, ad plate, pressure plate, etc.

4. Connect the module corresponding line, and double check no wrong, if you Connected the wrong cause the module to burst

5. Installed in the original radiator position, note the insulation, do not short-circuit

6. It is energized, the measured voltage is not output, there is no reason to check if the output



Note:

1. Before using this module, there is no need to detect short-circuit the cold side, there is a short circuit in the first repaired, if the need to replace the capacitor drum kits, ignition coil circuit shorted Esen disconnected, no prior on the module, removed the original chip and module power mos tube, this time the original switch in the middle of the electrode to heat to have voltage 300v voltage around.

2. Optocoupler 3 feet, if not Connected the heat, the heat please 3 feet to ground, while the demolition of empty 4-pin peripheral circuit, and the white wire to the position 4 feet.

 


General
Brand: MaiTech
Quantity: 1Piece
Color: Black
Material: Plastic + iron

Specification
English Manual / Spec: No

Other Features
Certification: N/A

Dimensions & Weight
Dimensions: 0.91 in x 0.87 in x 0.39 in (2.3 cm x 2.2 cm x 1 cm)
Weight: 0.21 oz (6 g)

Packing List

1 x Module (9cm-cable)
Tags:

power supply calculator

,

universal power adapter

,

power blackout

,

monitor power cable

,

power modules

,

black power ranger

,

power monitors inc

,

maintech power